Guide Canicom GPS
–
Indice B
23/84
❶
On/Off, Back or Back to home key
❷
Key to see the different dog groups (in the tracking menu) or to confirm your choice in other
screens
❸
Vibration key
❹
Stimulation key
❺
Arrows to move through the menus
❻
Central key on the pad to confirm
Charging the geolocation system
Before using the system, we recommend that you fully charge the collar and the handheld.
It takes around 3 hours to fully charge your system.
▪
Charge the collar
−
Connect the charger to the USB cable then connect the assembly to a mains socket.
−
Connect the collar's magnetic power supply lead.
CAUTION : the collar must be off
during charging.
After a few seconds, the red LED lights up steady.
−
Once the battery is fully charged, the green LED lights up steady.
−
Disconnect the charger from the tracker and then from the wall socket.
To increase your battery's lifetime, we recommend that you disconnect your collar as soon as it is
charged.
▪
Charge the handheld
−
Connect the charger to the USB cable then connect the assembly to a mains socket.
−
Connect the magnetic power supply lead to the handheld.
CAUTION: the handheld
must be turned off during charging.
After a few seconds, the charging icon is displayed
on the screen.
−
Once the battery is fully charged, the battery icon will be full.
−
Disconnect the charger from the handheld and then from the wall socket.
To increase your battery's lifetime, we recommend that you disconnect your handheld as soon as it is
charged.
How to start up your geolocation system
▪
Switching the collar on/off
Tip
:
Do not switch your collar on inside a building or home. Go outside and choose a clear area. Do not
stand under any trees or dense foliage or in a place where satellite signals could be blocked by large
obstacles (blocks of flats, ravines, etc.).
To
switch your collar on
, simply press and hold the on/off button on the top of the collar : the
collar vibrates 3 times quite quickly and the two LEDs on the front light up, and then the green LED
flashes several times in rapid succession.
Your collar is now working.
The red LED then starts to flash, indicating that the collar is looking for the GPS. As soon as it captures
the GPS signal, the LEDs (green and red) flash more slowly and alternately.
Your collar is ready to be
paired with the handheld.
❺
