the unit as well as prevent corrosion that can occur with hot stamping units.
Do not attempt to lubricate with any other lubricant; some lubricants will break
down and leave deposits on the wheels, which can cause the wheels to bind.
5. Allow ample warm up time before stamping. A large mass of metal will heat
slowly.
6. Do not attempt to clean a numbering head before disconnecting the power
and allowing it to cool. The heating elements, when on, are much hotter than
the flash point of most solvents.
7. Protect heater wires and thermocouple leads. These wires are fragile and
could easily be broken.
8. Make sure the heaters are mounted well into the frame with no parts
exposed. Exposed heater sections will overheat and could damage the
element.
9.
A CLEAN HEAD IS A MUST. A MAINTENANCE SCHEDULE MUST BE
DETERMINED SO THAT EXCESSIVE DOWNTIME OR DAMAGE CAN BE
AVOIDED.
When ordering parts or obtaining information, always mention the serial number.
If you have any questions or problems our sales department is at your disposal.
Revision # 2.0
