You must have a dealer account set up before you can proceed. If your company already has an account set
up, do the following:
1
At the bottom of the web page, click the activation link. The member
Login
screen appears.
2
At the
Login
screen, type your login name and password, then click
Login
.
3
The following options are available on the site map. If not displayed, select
Site map
under the
main menu.
Activate digital unit (new).
This will activate the GSM module (NX-594). Enter the serial number of
the module (located on the front of the unit). The serial number must contain 10 digits. Multiple modules
can be added from this screen.
Edit unit settings.
Complete the following information based on the way you want to configure the
reporting for the module:
•
Select the unit you have just activated.
•
Add the account name to the
Unit name
field.
•
Select your
Notification Method 1
.
•
Change
TX Retries
to 8 (maximum allowed).
•
•
Go to the appropriate field for the
Method 1
that was chosen (Alpha, E-mail, or Central
Station).
•
If
Alpha
pager, the PIN is required.
•
If
Central Station
, enter the receiver phone number and central station A/C number.
•
Select a second
Notification Type
, if needed.
•
Notification Enabled
should read “Yes”.
4.
Click
Update
.
Enrolling the module
The NetworX control panels have the ability to automatically find and store in memory the presence of all
keypads, zone expanders, wireless receivers, and any other device on the keypad buss. This allows these
devices to be supervised by the control panel. To enroll the devices, enter program mode of the NX control
panel using the procedure described in the control panel documentation. When you exit program mode, the
control panel will automatically enroll all the devices. The enrolling process takes about 12 seconds, during
which time the service LED will illuminate. When using the LCD keypad, the “Service Required” message
will be displayed. User codes will not be accepted during the enrolling process. Once a module is enrolled, if
the control panel does not detect it, the service LED will illuminate.
Module address
The GSM module has a fixed address of 76. When programming the module, enter program mode and select
the device address as 76 (see
Programming
on page 8).
