25
24
IN
S
TA
LL
A
TION
IN
S
TA
LL
A
TION
If the car is fitted with a
child restraint anchorage
point:
Locate the anchorage point
behind the rear seating
position (consult the vehicle
owners handbook for loca-
tion of the anchorage point).
Remove the thread plug from
the parcel shelf/floor/roof
and install the attachment
bolt as shown opposite.
CAUTION:
DO NOT OVERTIGHTEN
THE ATTACHMENT BOLT.
MAXIMUM TORQUE 20Nm.
Attachment
Bolt
Lock
Washer
Spacers (if
required)
Anchor
Fitting
Vehicle
Metal
Structure
Vehicle
Trim
FRONT OF VEHICLE
WARNING
CHILD RESTRAINTS MUST NOT BE ATTACHED TO UNSOUND
METAL OR WOOD OR SYNTHETIC STRUCTURES. WHEN
DRILLING THE 9 MM HOLE DO NOT DRILL THROUGH FUEL
LINES, FUEL TANKS, ELECTRICAL WIRING, OR RADIO
SPEAKERS. WEBBING STRAPS MUST BE PROTECTED FROM
SHARP CORNERS AND EDGES.
THE ANCHOR FITTING MUST BE USED ONLY AS DESCRIBED
ABOVE. IT MUST NOT BE HOOKED ONTO ANY OTHER
OBJECT.
Tether Anchorage - Installation
If the car is not fitted with
a child restraint anchorage
point:
For sedans only
- drill a 9
mm hole in the parcel shelf
on the centre line of the
seating position as shown
on page 27.
Install the anchor bolt as
shown opposite.
It is recommended that this
installation be carried out by
a child restraint fitting station
or licenced motor mechanic.
For vehicles other than
sedans
- In Australia,
consult your nearest child
restraint fitting station or
traffic authority for vehicle
inspection to find the best,
correct position for the
placement of the anchorage
point, and for the correct
attachment bolt length and
use of spacers.
In New Zealand, consult the
agent for the vehicle.
Attachment
Bolt
Spacers
(if required)
Anchor
Fitting
Vehicle
Metal
Structure
Vehicle Trim
FRONT OF VEHICLE
Lock
Washer
Nut
Reinforcing
Washer
Tether Anchorage - Installation
