DSP LASER AP with MCS
8.
Overview
8.1.
System composition
8.1.1. MCS module
MCS is an electronic module whose logic has been planned to monitor and operate the
systems and the components, present on a press brake, which ensure a safe use of the
press itself according to what foreseen by standard EN12622.
The concepts used for its design and manufacturing allows achieving, for some safety
functions, the category 4, PL=e according to standard EN ISO 13849-1 and SILCL3
according to standard EN 62061, the highest possible as regards the realization of
equipment preposed to the costruction of safe machines. The structure is characterized by
two processors and, then, two channels, usually named “Channel A” and “Channel B”.
The system nature and its partial capability to be programmed allow the adaptation and the
use of the press brake in different planning methods.
Types of front protections controlled by MCS
As you can see in Figure 1, MCS controls the photoelectric device DSP LASER AP as main
component for the protection against the access to the front part of the bending machine.
This generates a protection photoelectric area with advanced characteristics, allowing the
achievement of high machine performances, ensuring however a very high protection
degree for the operator.
MCS can manage even the protection photoelectric area generated by DSP LASER or by a
generic protection barrier. In this case, refer to the manual of the device you wish to use.
Information
:
The standard version of MCS software is the PS version suitable to the
use of DSP LASER AP. If you use MCS with a device different from DSP
LASER AP, make sure to have purchased the version with the special
PG software version installed.
Figure 1
DSP LASER AP
DSP LASER
PHOTOELECTRIC BARRIER
M
C
S
8
DLAM01EN
Summary of Contents for DSP LASER AP
Page 2: ......
Page 4: ......
Page 50: ...DSP LASER AP with MCS Figure 34 44 DLAM01EN...
