DSP LASER AP with MCS
•
The distance between the front part of TX and RX and the basement of the press is
greater than or equal to 100 mm, with the purpose to avoid the hand squashing.
•
The design of the moving support of the device must be such not to create
entrapment points during the upward and downward movements of the press.
•
Additional protections must be used to eliminate the dangers which can arise from
DSP LASER (for example, between DSP LASER and the fixed part of the press) and
to allow the access to the die area only passing through the front area.
•
The device must be protected against the accidental shocks which could damage it or
change its setting.
•
The stroke of the supports is such to allow:
•
the correct use of the tools with minimum and maximum height, indicated by the
press manufacturer
Information
:
Install the minimum height tool, move the TX and RX supports as high as
possible and lock them in this position. Verify that the beam is interrupted
by the tool.
Install the maximum height tool, move the TX and RX supports as low as
possible and lock them in this position. Verify that the beam is not
interrupted by the tool.
•
the removal of the tools without having to remove the devices and/or the supports
(e.g: possibility to extract the tools with TX fully lifted)
•
the fastening of the supports, once adjusted, is safe against the accidental loosening
Caution:
Use all the possible precautions in order to reduce the machine vibrations.
Protect the devices and the supports with material protections in such a way
to avoid the shocks.
32
DLAM01EN
Summary of Contents for DSP LASER AP
Page 2: ......
Page 4: ......
Page 50: ...DSP LASER AP with MCS Figure 34 44 DLAM01EN...
