DSP LASER AP with MCS
10.3.2.2. Installation
TX and RX containers are provided with four stud bolts (Figure 28) for the fastening to the
corresponding moving supports. Fasten, then, TX and RX to the supports by means of
these couplings and tighten the supplied 5MA thread nuts.
Caution:
Make sure the nuts are tighten in such a way the machine vibrations do not
loose them. The torque of the screws must not be less than 1.96 N*m
(20 kg
f
*cm).
The devices must be fastened to the supports in such a way that:
•
The central vertical protection layer of TX and RX can be
not more
than 2mm
beyond
the tool axis in direction of the rear part of the press, as visible in Figure 30.
Figure 30
DLAM01EN
33
Summary of Contents for DSP LASER AP
Page 2: ......
Page 4: ......
Page 50: ...DSP LASER AP with MCS Figure 34 44 DLAM01EN...
