DSP LASER AP with MCS
Repeat the operation for all the five numbers composing the Password.
If the entered Password was not correct, the display looks like in Figure 49.
Figure 49
In this case, in order to execute other operations or to insert again the Password, it is
necessary to switch off the equipment.
•
If the entered Password is instead correct, the display looks like in Figure 50.
Figure 50
•
Press again
Enter
to modify the machine parameters. The parameters are
displayed in sequence as in the table of par. 11.2.1 and can be read or updated by
making they scroll on the display using the key
Enter
.
Once the wished parameter has been displayed, by means of
Arrow Up
and
Arrow
Down
keys, you can choose the value or the function to assign confirming then with
Enter
. In Figure 51, for example, the value 13 has been assigned to parameter A2.
Figure 51
The assignment of the machine state to the safety outputs, to the generic outputs and to the
monitors (parameters C1÷C17) takes place considering groups of four bits (three in case of
C14) each time.
DLAM01EN
65
Summary of Contents for DSP LASER AP
Page 2: ......
Page 4: ......
Page 50: ...DSP LASER AP with MCS Figure 34 44 DLAM01EN...
