DSP LASER AP with MCS
the outputs to ON state and, then, it is possible to command again the downstroke of the
press in high speed.
Residual
risk
:
In this operating mode, part of the detection area is inhibited. It is
necessary that the operator is informed about the residual possibility of
squashing between the punch and the die or between the punch and the
piece in processing.
In order to minimize the dangerous area, the length of the tools shall be
the minimum necessary for the current processing.
11.10. Operation in Robot mode
When a robot is used to feed the bending pieces to press brakes, MCS must disable the
function of Speed Control, Encoder Control, DSP LASER AP Control and Side Guard
Control.
To access to this operating mode, the relevant selector must be activated and MCS must
receive the proper signals from CNC via RS232.
In alternative, the robot function can be commanded from the safety PLC of the robot itself.
For the installation and the operation of the machine with the robot, all the precautions must
be taken and all the obligations required by the system must be respected.
For the realization of this function, it is necessary to call NUOVA ELETTRONICA s.n.c. of
Pasqui F. & C. in order to get the information necessary for the correct management of this
function.
Warning
:
This working mode is reserved to machine equipped with fence,
destinated to be controlled by Robot.
Improper use of this function could cause serious dangers for the
operators.
86
DLAM01EN
Summary of Contents for DSP LASER AP
Page 2: ......
Page 4: ......
Page 50: ...DSP LASER AP with MCS Figure 34 44 DLAM01EN...
