6
ENGLISH
OPERATION
!
Caution:
FIGURE 2
6. The finished laminated item will roll out through the exit slot on the back of the laminator.
7. Push control switch back to “OFF” to power off the laminator after use.
COLD LAMINATING
When switching over to the Cold lamination mode immediately after Hot laminating, please wait at
least 60 minutes for the laminator to cool down before use. If laminator is too hot for Cold lamination,
item being laminated could be damaged.
1. Insert the power plug into an electrical socket.
2. Push the control switch to "COLD ". The motor will start up and the red “POWER” indicator light
will turn on.
4. Put the item being laminated into a laminating film leaving a 1/8"-3/8" border from the sealed
end of the pouch.
5. Insert them together into the feed entry at the front of the laminator.
Be sure to insert with the closed (sealed) edge of the laminating pouch first.
6. The finished laminated item will roll out through the exit slot on the back of the laminator.
7. Push control switch back to “OFF” to power off the laminator after use.
WHEN FINISHED LAMINATING:
When the laminated item exits, it may be very hot and soft. Handle the lami-
nated item with care. Pressing the item with a book or other heavy objects may
help make it flat and smooth.
JAM RELEASE LEVER (CLEAR JAMMED ITEMS)
This laminator features a Jam Release lever to easily clear stuck items in the machine. Please
refer to "Troubleshooting" at page 8.
Summary of Contents for LM992HC
Page 2: ......
