- PAGE 2 -
F
Turn the chair right side up and install the backrest
assembly. Slide the two backposts into the back of the seat
frame and tighten the two socket head cap screws using
the ¼" Allen wrench (Refer to Figures 4 & 5). Also tighten
the four button head capscrews that attach the back cush-
ion to the back posts using the 5/32” Allen wrench (Refer to
Figure 6).
G
Place the connector bridge into the matching holes on
both the roll-in section and tub section (Refer to Figure 7).
Figure 4
SAFETY PRECAUTION!
Both backrest posts must be completely engaged with the seat
frame and securely tightened. If they are not fitted correctly, there
is a risk of the posts dislodging from the seat frame.
This could cause serious injury or even death!
Figure 7
SAFETY PRECAUTION!
The connector bridge must be fully seated into the corresponding
holes of both the roll-in section and tub section. If this is not done
correctly, the seat frame could dislodge itself from the chair when
transferring from the roll-in section to the tub section.
This could cause serious injury or even death!
Figure 5
Figure 6
