Reconfigure the multiCHAIR 5200 with the Tub
Section on the user’s right side (Refer to Figure 7):
1) Remove the commode section legs from the frame (Refer
to Figure 8)
2) Rotate the frame 180 degrees (Refer to Figure 8)
3) Re-install the legs (Refer to Figure 8)
4) Reverse the release latch: Use the provided black L-Handle
wrench to remove the latch by unscrewing the two machine
screws, which attach it to the seat frame. Re-install the
release latch on the opposite side of the seat frame (Refer to
Figure 9).
5) Follow the Assembly Instructions (Pages 1-2) to configure
the rest of the chair.
ADDITIONAL ASSEMBLY INSTRUCTIONS
NOTE!
Assemble the multiCHAIR 5000 to the factory setting (with the
tub on the user’s left side) first, following the Assembly
Instructions (Pages 1-2). Then, if desired, follow the Additional
Assembly Instructions to reconfigure the chair with the Tub
Section on the user’s right side.
(2) Machine
Screws
Release Latch
Figure 9
NOTE!
Release Latch Assembly: Do not attempt to unscrew
the inner slotted screws. Doing so can cause the
entire latch assembly to come apart, rendering it use-
less (There is no tool provided for this operation) .
- PAGE 3 -
Connector Bridge
Tub Section
Figure 7
multiCHAIR 5000
Figure 8
Commode Section