6.2 Reverse installation
Step 1
.
For Group 0+,the safety position of the safety seat must
only be used in the most reclined position(see Fig.1/a).The safety
seat must never be used in any other position(Fig.1/b).To adjust
the reclining position of the safety seat,press the red incline adjuster
button(Fig.2) ,Untill you reach the required position(Fig.3).
Fig
.
2
Step
2
.
The
seat
must always
be
rearfacing (Fig.4/a).If your car has
an airbag on the passenger seat,the safety seat must only be used on
the rear seat.
Fig
.
1/a
Step 3
.
secure
the
safety
seat
onto
the
car
seat
using the car seat
belt
Step 4.
pass the lap part of the seat belt under the base of the safety
seat(A) into the two points marked by a blue label and fasten the
clip to the corresponding buckle(C)
Step 6
.
Place
the red clip(D) on the shoulder belt directly upwards
at the place where lap and shoulder belt are splitted up.
8
Fig
.
1/b
C
B
D
Step7.
Make sure that the belt is not twisted and strongly tightened
before you block the belt with the plastic clip.
Step 5.
pass the upper diagonal part of the belt in the metallic guide(B)
Fig
.
3
Fig
.
4/a
Fig
.
4/c
Fig
.
4/b