5
Maintenance
To receive reliable service from this equipment, regular daily
maintenance is a requirement. Fabric cleaning, both carpet
and upholstery, are very dirty environments for any equipment.
The following recommendations are offered.
1. Keep the equipment clean, both inside and out.
2. Lubricate brass quick disconnects and drain valves with
a quality lubricant such as WD-40.
3. Flush solution systems after use with clear, clean water.
(A white vinegar solution may also be used). This will
counter-act hard water and alkaline deposits and aid
in keeping orifices clean.
4. Do not allow fluid either in solution or waste tank to sit
overnight. The unit should be emptied and cleaned daily.
5. Clean the strainer in the solution tank, the filters on the
vacuum stack in vacuum tank and all lint filters in the
inlet or vacuum tanks daily.
6. Do not use the same receptacle (pail) to fill solution
tank that is used to remove waste from vacuum tank.
7. When the unit is not in use, leave the vacuum tank lid
open.
8. At the end of each day, run the vacuum for 3 minutes
with lid open and filter off.
Safety Precautions
These precautions are designed with the safety of the operator,
the equipment, and others in mind and must be followed at all
times to avoid serious personal harm and/or death, and dam-
age to the unit.
1. Always use a grounded electrical outlet.
2. Always disconnect electric cable from electrical outlet
before attempting to make any adjustments or repairs.
3. Never use this equipment as a toy.
4. Never use equipment near or around flammable or
explosive materials, fuels, or solvents.
5. Never put flammable materials, fuels, or solvents
into equipment.
6. Never lift the machine by the drain hose.
7.
Do not allow the unit to freeze!
8. The equipment was not designed to be used outdoors
or in the rain.
9. Do not operate in standing water.
10. Wear safety equipment and clothing to protect from
extremely hot water.
11. Do not operate equipment under any unsafe condition.
