Page 10 of 15
F2
Zero run
The Zero run is provided to electrically compensate the unbalance of the adaptor or clamping
means.
Whenever the clamping means has been dismounted and replaced a compensation of the
residual unbalance in the adapter and clamping means should be carried out.
Routine:
MACHINES with manual clamping of the wheel
Remove the cones and clamp from the adaptor.
Press the function key to select the function menu.
Use +/- keys to select the Function 2.
Press function key again to activate the function.
Press START to start the run.
The residual unbalance of the adaptor is calculated and saved in the
memory. (This value stays in the memory even after switching off the
power). After the run has finished, the program automatically changes
to normal mode.
MACHINES with QuickSpan
:
Attach the pressure cup for steel rims to the clamping sleeve and
activate the QuickSpan
Press the function key to select the function menu.
Use +/- keys to select the Function 2.
Press function key again to activate the function.
Press START to start the run.
The residual unbalance of the adaptor is calculated and saved in
the memory. (This value stays in the memory even after switching
off the power). After the run has finished, the program
automatically changes to normal mode.
F 6
Autorun
If Autorun is active (ON) the balancing run is started when the wheel guard is closed. If Autorun is
not active (OFF) the balancing run needs to be started by pushing the START button when the
wheel guard is closed.
