2
All On/All Off
The NPD300Z supports the ALL ON/ALL OFF commands.
The NPD300Z can be set to respond to ALL ON and ALL OFF commands
four different ways. Refer to your controller for information on how to set the
NPD300Z to operate in the manner you desire. Some controllers may be only
able to set certain settings of ALL ON / ALL OFF response.
The four different ways the NPD300Z can be set up to respond to ALL ON and
ALL OFF commands are:
• NPD300Z will not respond to ALL ON or the ALL OFF command.
• NPD300Z will respond to ALL OFF command but will not respond to ALL
ON command.
• NPD300Z will respond to ALL ON command but will not respond to ALL
OFF command.
• NPD300Z will respond to ALL ON and the ALL OFF command.
Manufacturer Specific
The NPD300Z supports the Manufacturer Specific Command. The NPD300Z
can return Manufacturer Specific information about itself. Refer to your
controller’s instructions on how to get this information from the NPD300Z.
CONFIGURATION
The NPD300Z supports the Configuration command.
The NPD300Z can
be configured to operate slightly differently than it works when you first install
it. Using the configuration command you can change the following (if your
controller supports it)
Load Sense:
• Parameter No 29
• Length: 1 Byte
• Valid Values = 0 or 1 (default 1)
Set this parameter to 0 to disable load sense. Set this parameter to 1 to enable
load sense.
SPECIFICATIONS
Power:
120VAC, 60 Hz
Signal (Frequency):
908.42MHz
Maximum Load:
300 W, for incandescent lamps only
NOTE:
A minimum of 20 watt load is
recommended for the “Load Sense” feature and
dimming capabilities of this product to operate
properly.
Range:
Up to 100 feet line of sight between the Controller
and or closest Z-Wave repeater
REGULATORY INFORMATION
The NPD300Z is certified to comply with applicable FCC and IC rules and regulations governing RF and EMI emissions.
FCC NOTICE
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) This device must accept any interference received, including interference that may
cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to
operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
IC NOTICE
This Class B digital apparatus complies with Canadian ICES-003. Operation is subject to the following two conditions: (1) this
device may not cause interference, and (2) this device must accept any interference, including interference that may cause
undesired operation of the device.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada. Le présent appareil est conforme aux
CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions
suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.
Les changements ou modifications non approuvés expressément par la partie responsable de la conformité pourrait annuler
l’autorité de l’utilisateur à faire fonctionner l’équipement.
LIMITED WARRANTY
WARRANTY PERIOD AND EXCLUSIONS:
Broan-NuTone LLC (the “Company”) warrants to the original consumer
purchaser of its product (the “Product”) that the product will be free from material defects in the Product or its workmanship
for a period of one (1) year from the date of original purchase. The warranty on the light bulbs provided with the product is one
(1) year and does not cover lamp/bulb breakage. This warranty does not cover accessories or parts that may be purchased
separately and installed with the Product.
The limited warranty period for replacement parts, and for Products repaired or replaced under this limited warranty, shall
continue for the remainder of the original warranty period.
NO OTHER WARRANTIES: THE FOREGOING WARRANTIES ARE EXCLUSIVE AND IN LIEU OF ANY OTHER
WARRANTIES, EXPRESS OR IMPLIED. THE COMPANY DISCLAIMS AND EXCLUDES ALL OTHER EXPRESS
WARRANTIES, AND DISCLAIMS AND EXCLUDES ALL WARRANTIES IMPLIED BY LAW, INCLUDING WITHOUT
LIMITATION THOSE OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. TO THE EXTENT
THAT APPLICABLE LAW PROHIBITS THE EXCLUSION OF IMPLIED WARRANTIES, THE DURATION OF ANY
APPLICABLE IMPLIED WARRANTY IS LIMITED TO THE PERIOD SPECIFIED FOR THE EXPRESS WARRANTY.
Some
states do not allow limitations on how long an implied warranty lasts, so the above limitation may not apply to you. Any oral or
written description of the Product is for the sole purpose of identifying it and shall not be construed as an express warranty.
REMEDY:
During the applicable limited warranty period, the Company will, at its option, provide replacement parts for, or
repair or replace, without charge, any Product or part thereof, to the extent the Company finds it to be covered by and in
breach of this limited warranty under normal use and service. The Company will ship the repaired or replaced Product or
replacement parts to you at no charge. You are responsible for all costs for removal, reinstallation and shipping, insurance or
other freight charges incurred in the shipment of the Product or part to the Company. The Company reserves the right to utilize
reconditioned, refurbished, repaired or remanufactured Products or parts in the warranty repair or replacement process. Such
Products and parts will be comparable in function and performance to an original Product or part and warranted for the
remainder of the original warranty period. This warranty does not cover (a) normal maintenance and service including light
bulbs, batteries or other accessories, (b) normal wear and tear, (c) any Products or parts which have been subject to misuse,
abuse, abnormal usage, negligence, accident, improper or insufficient maintenance, storage or repair (other than repair by
the Company), (d) damage caused by faulty installation, or installation or use contrary to recommendations or instructions,
(e) any Product that has been moved from its original point of installation, (f) damage caused by environmental or natural
elements, (g) damage in transit, (h) natural wear of finish, (i) Products in commercial or nonresidential use, or (j) damage
caused by fire, flood or other act of God. This warranty covers only Products sold to original consumers in the United States
by the Company or U.S. distributors authorized by the Company.
EXCLUSION OF DAMAGES: THE COMPANY’S OBLIGATION TO PROVIDE REPLACEMENT PARTS, OR REPAIR OR
REPLACE, AT THE COMPANY’S OPTION, SHALL BE YOUR SOLE AND EXCLUSIVE REMEDY UNDER THIS LIMITED
WARRANTY AND THE COMPANY’S SOLE AND EXCLUSIVE OBLIGATION. THE COMPANY SHALL NOT BE LIABLE
FOR INCIDENTAL, INDIRECT, CONSEQUENTIAL OR SPECIAL DAMAGES ARISING OUT OF OR IN CONNECTION
WITH THE PRODUCT, ITS USE OR PERFORMANCE.
Incidental damages include but are not limited to such damages
as loss of time and loss of use. Consequential damages include but are not limited to the cost of repairing or replacing other
property which was damaged if the Product does not work properly.
Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or
exclusion may not apply to you. This warranty gives you specific legal rights, and you may also have other rights, which vary
from state to state.
This warranty supersedes all prior warranties and is not transferable from the original consumer purchaser.
THE COMPANY SHALL NOT BE LIABLE TO YOU, OR TO ANYONE CLAIMING UNDER YOU, FOR ANY OTHER
OBLIGATIONS OR LIABILITIES, INCLUDING, BUT NOT LIMITED TO, OBLIGATIONS OR LIABILITIES ARISING
OUT OF BREACH OF CONTRACT OR WARRANTY, NEGLIGENCE OR OTHER TORT OR ANY THEORY OF STRICT
LIABILITY, WITH RESPECT TO THE PRODUCT OR THE COMPANY’S ACTS OR OMISSIONS OR OTHERWISE.
This warranty covers only replacement or repair of defective Products or parts thereof at the Company’s main facility and does
not include the cost of field service travel and living expenses.
GENERAL PROVISIONS:
(1) Any assistance Company provides to or procures for consumer outside the terms, limitations
or exclusions of this warranty will not constitute a waiver of such terms, limitations or exclusions, or extend or revive the
warranty. (2) Any action by you for breach of this limited warranty must be commenced within one year after the breach
occurs. (3) Whenever possible, each provision of this limited warranty shall be interpreted in such manner as to be effective
and valid under applicable law, but if any portion is deemed invalid or unenforceable, the remaining portions shall still be
enforceable. The Company will not reimburse you for any expenses incurred by you in repairing or replacing any defective
Product, except for those incurred with the Company’s prior written permission.
The Company will not reimburse you for any expenses incurred by you in repairing or replacing any defective Product, except
for those incurred with the Company’s prior written permission.
HOW TO OBTAIN WARRANTY SERVICE:
To qualify for warranty service, you must (a) notify the Company at the address
or telephone number stated below within seven (7) days of discovering the covered defect, (b) give the model number and
part identification and (c) describe the nature of any defect in the Product or part. At the time of requesting warranty service,
you must present evidence of the original purchase date. If you cannot provide a copy of the original written limited warranty,
then the terms of the Company’s most current written limited warranty for your particular product will control. The most current
limited written warranties for the Company’s products can be found at www.NuTone.com .
Broan-NuTone LLC 926 West State Street, Hartford, WI 53027 www.NuTone.com Toll Free (855) 249-0610
If you must send the Product or part to the Company, as instructed by the Company, you must properly pack the Product or
part—the Company is not responsible for damage in transit.
PRINTER’S INSTRUCTIONS:
INSTR,INSTL,NPD300Z; P/N: 10005982 X2 INK: BLACK; MATERIAL: 20# MEAD BOND; SIZE: 8.500” x 11.000”; TOL ± .125”; SCALE: 1-1; PAGE 2 OF 2
Copyright © 2015 Broan-NuTone LLC
10005982 X2
Z-Wave
®
is a registered trademark of Sigma Designs
