Safety Notice
In order to avoid any accidents, please refer to following operation:
1. Disconnect power before servicing.
2. Do not pull directly on wire when plugging or unplugging the unit.
3. If ice is abnormal, please call the seller.
4. It is normal for the compressor and condenser surface to reach temperatures between 70°C and
90°C during operation and surrounding areas may be hot. Please don't touch it.
5. Due to fast freezing, ice cubes may appear “Cloudy”. This is trapped air in the water and it will not
affect quality or taste of ice.
6. When out of use, please open the drawer at least 2cm to allow for air circulation and avoid any
metallic components becoming rusted.
7. If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a
similarly qualified person in order to avoid a hazard.
8. This appliance can be used by children aged from 8years and above and persons with reduced
physical, sensory or mental capabilities or lack of experience and knowledge if they have been
given supervision or instruction concerning use of the appliance in a safe way and understand the
hazards involved.
9.Children shall not play with the appliance.
Cleaning and user maintenance shall not be made by children without supervision.
10. WARNING: fill with bottled or good quality tap water only. (Do not fill with fruit juices or other
drink types).
11. WARNING
– Keep the air vents on the sides of the machine unblocked at all times.
12. WARNING
– Do not use mechanical devices or other means to accelerate the defrosting
process, other than those recommended by the manufacturer.
13. WARNING
– Do not damage the refrigerant circuit.
14. WARNING
– Do not use electrical appliances inside the food storage compartments of the
appliance, unless they are of the type recommended by the manufacturer.
Troubleshooting
1. Please note, if a power failure occurs due to disconnection of the power cord, or the off power button
has been pushed off during an ice making cycle, small ice chips may formed and lodge in the automatic
shovel causing it to jam. If this occurs, the ice chips may be removed by disconnecting the power cord
and gently pushing the shovel to the rear of the cabinet and removing the ice chips, then restarting.
2. Please restart the ice maker by pressing Stop and then Start. If the Ice shovel does not push the Ice
into the Ice collector after the formed Ice drops from the evaporator finger while at the same time the M
light is on, check to see if the water tray is horizontal or balanced. If not then adjust by pressing the Ice
shovel lightly with your finger. Then re-start the Ice maker.
