● Cleaning
1. Make sure to unplug the appliance before cleaning and long time of non-use.
2. Use a damp cloth to clean both the interior and exterior of the appliance.
3. Water tank cleaning:
First Phase:
1) Add equal parts of water and vinegar (1:1) into water storage box.
2) With the stand-by mode, keep pressing ON/OFF switch at least 5 seconds
to activate self-cleaning mode. Please note self-cleaning mode will
automatically start after the “Beep” sound.
3) During the self-cleaning mode, pump will remain in continuous operation
as it feeds water to the bucket and evaporator coils. This cycle will continue
for 5 times.
4) Upon completion, the unit automatically changes to stand-by mode.
Second Phase:
1) Remove the rear drain cap and plug, and then drain off the water and grip
the nut.
2) Add fresh water to the maximum permit water volume line.
3) With the stand-by mode, keep pressing ON/OFF switch at least 5 seconds
to activate self-cleaning mode again which will now act as a rinse.
4) Upon completion of this final stage of the self-clean process, the unit
automatically changes to stand-by mode. Proceed to drain the water from
the internal reservoir by removing the rear drain cap and plug. Leave the
upper lid open to allow it to air dry.
4. Do not use organic solvents, boiling water, cleaning agents, strong acid ans alkali
etc. substances for cleaning.
5. If the ice machine will be off use for a long time, you should unplug the appliance,
drain off the water and dry the appliance with a clean cloth, store the ice maker in a
clean place.
6
Summary of Contents for PICEM70
Page 1: ......
