Disassembly
1)
Take off the fastening screw, and then Noodle Molding. See Figure 1 and 2.
2)
Take off the Front Panel, Mixing Tank and Mixing Screw. See Figure 3.
How to Assemble
1)
Put the Product on a stable counter, then put the Mixing Tank into the product. Insert the
Mixing Axis into the device. As seen in Figure 1 and 2.
2)
Put the Front Panel into the device through the Fastening Screw. As below Figure 3:
3)
Put the Noodle Molding into the Mixing Axis (The molding should be soaked in warm water
and mixed with oil; this will make the noodles smoother and taste better). Lock the three
screws as shown below in Figure 4.
