Cautions
1.
Before assemble the Noodle Molding into machine, put it into hot water for one minute. This
can help the noodles come out much easier.
2.
After continuous working of 3 times, the machine must stop and rest for 10 minutes.
3.
While the noodles come out, if the paste is too dry, the motor will be overloaded in making
the noodles. In this condition the motor will reverse and then stop working. Press “Cancel”,
add some more water inside and start mixing the flour again, then replace the Noodle
Molding.
4.
If there is paste left inside the Noodle Molding, please wait until it’s dry, then strike it on a
hard surface; the paste will drop off. If the paste is not dry yet, you can use a needle to clean
it.
5.
Below parts can be disassembled for cleaning: Mixing Tank, Mixing Axis, Supporting Board,
Noodle Molding, Fasten Screw. The screw did not contact the flour so just use wet cloth to
clean it. Never use a corrosive water to clean the machine body.
6.
Before disassemble the Mixing Tank, the Mixing Axis must be disassembled first. When
assemble the Mixing Axis, must make sure that it’s assembled well.
7.
If the machine is damaged or cannot operate, please don’t open the machine. Ask a
technician to check it.
8.
During working, there cannot be any hard objects inside the Mixing Tank.
9.
No matter if you disassemble, assemble or replace the parts, the electricity must be cut off.
During cleaning, please unplug the machine. Besides the Mixing Tank, Mixing Axis,
Supporting Board, Noodle Molding and Measuring Cup, no other parts can be put into water.
10.
If you want to open the Lid Cover while it’s running, please press the “Cancel” button to stop
the machine.
11.
If the weather is dry or rainy, please don’t use this machine outside of the house.
12.
This machine cannot be used by children or young adults without supervision.
13.
If the soft power cord is damage, it must be repaired or replaced by an authorized technician.
