www.NutriChefKitchen.com
5
www.NutriChefKitchen.com
4
STRUCTURE AND FUNCTIONS
1.
“Mode” button:
It has two setting mode (
Normal and Gentle
). The default
mode is Normal. When the food is crumbly, you can press the button, then the
vacuum mode is changed to Gentle. You can manually control the degree of
vacuum by pressing “
Seal
” button at any time, the food will be sealed
automatically. (
Note:
if the power is interrupted, this setting will return to a
preset standard mode).
2.
“Food” button:
It has two setting mode (
Dry and Moist
). The default mode is
Dry, when you press the button, it change to Moist mode. You can choose the
model according to the food type.
3.
“Seal” button (with LED):
Press this button to seal bag (intervals for 40 seconds
is recommended each time)
4.
“Vac/Seal” button:
Press this button to vacuum and seal bag (intervals for 40
seconds is recommended each time)
5.
“Canister” button (with LED):
Press this button, the appliance can marinate
the food by vacuum cycles, you can get great flavor in shortest time.
(
Note:
This function is used together with the Nutrichef canister).
6.
“Pickling” button (with LED):
Press this button, the appliance can marinate
the food by vacuum cycles, you can get great flavor in shortest time.
(
Note:
This function is used together with the Nutrichef canister )
7.
“Pulse Vac” button (with LED):
Used to prevent crushing of delicate.
Press once and then press again and hold to control the vacuum process.
8.
“Stop” button:
Allows user to stop working anytime.
9.
Vacuum Nozzle:
This is used for removing air from bags/canisters/bottles.
Insert the air suction hose into the nozzle. Do not block this nozzle when
vacuuming a bag.
A.
Cutter:
Cut the bag to any size you want.
B.
Roll Lid:
Open this lid, and then put the roll inside chamber.
C.
Lower Gasket:
Airproof the vacuum area and prevent leaking for the vacuum
D.
Rubber Lip:
make seal flat
E.
Sealing Bar:
3mm width sealing bar make good seal
F.
Vacuum Nozzle:
When pumping external vacuum canister, wine stopper or
other accessories, insert the hose into the nozzle. Do not block the the nozzle
when use
G.
Power plug:
Plug in the wire when in use. Unplug it while not in use or moving
the device
H.
Fuse base:
The fuse will be cut off when overloading. You can rotate the fuse
holder and replace the fuse. You can continue to use the sealer after fuse well
installed.
I.
Power switch:
Press this button to connect or disconnect the power.
Press "
I
" to connect while "
O
" to disconnect
Pulse
Vac
Stop/Start
3
8
2
1
4
7
6
5
9
A
B
C
D
E
F
G
H
I
