NutriMill plus, Owner'S Manual

5

NUTRIMILL® PLUS  SAFETY INSTRUCTIONS

• Always be sure the air router guide and the cyclo-cap are properly attached before 

milling. 

• Always be sure the air filter is in place before milling. 
• Always be sure your flour canister is connected and positioned correctly and that the 

lid is tight before milling. 

• Always check your grain for foreign objects before milling. Do not use grain that has 

not been cleaned during the manufacturing process. We recommend purchasing and 

using grain from a reliable source. 

• Do not let the flour canister become over-filled. It is easy to empty the canister and 

continue milling. 

• Do not mill damp, wet, or oily grains. Do not mill any seeds, nuts, sugars, or spices.
• Always clean the filter, air router guide, and cyclo-cap after milling by tapping out 

excess flour. Wipe out any remaining flour particles with a cloth or small brush.

• All service and repairs must be done by an authorized service center. For service 

information, see the warranty information on the last page of this manual.

KNOW YOUR NUTRIMILL®

• The control knob is both the on-off switch and the grain flow control gate.
• Make sure the knob indicator is straight up (off position) before you plug into the 

electrical outlet. Turning the knob to the right will turn on the mill motor.  As you 

continue to turn the knob to the right, you will hear grain begin to drop into the 

milling chamber. This position is the slowest feed rate possible and usually does not 

feed smoothly. Open the gate a little more for smooth grain flow.

• A slower feed rate usually results in a finer flour, depending on the motor speed.  A 

faster feed rate will result in a coarser flour. As a guideline: a full hopper of wheat will 

mill into wonderful bread flour in about 5 to 6 minutes.

• The feed gate will need to be wide open (set dial all the way to the right) to mill the 

largest legumes.

• The motor speed control is the switch in the center of the control knob. Press the 

top of the switch for high speed to yield finer flour.  When the switch is down for 

low speed, flour texture will be more coarse. When turning on the mill, start with the 

motor switch in the down position, then turn it to high after the mill has started. 

FIRST TIME YOU USE YOUR NUTRIMILL®

Mill at least 2 cups of wheat or other hard grain, then discard the flour and clean 

the canister. This will eliminate any contaminates the mill may have obtained in the 

manufacturing process. Make sure to use clean grain. Your warranty does not cover 

foreign object damage from plastics, metals, rocks or any other materials that could get 

into the milling heads. Proper care of your mill will ensure a reliable milling experience for 

many years to come.