nVent.com
|
38
Raychem-AR-H
58686
-NGC
40
DemoUnit-EN-
1805
7.3 Monitoring the NGC-40-SLIM module
Step
1
–
Click on the Monitor button located at the bottom of the screen. The screen below will be shown. This screen shows the status
of the Limiter output and alarm relay output. Also shown on this screen are the analog readings for all three temperature sensors.
Step
2
–
Setting the NGC-
40
Demo Controls
Set the controls on the NGC-
40
Demo as shown below.
Step
3
–
If the NGC-
40
-SLIM and NGC-
40
-HTC
3
are already in alarm then follow these instructions to clear the alarm otherwise go to step
4
.
• If the NGC-
40
-SLIM module was already tripped then reset the module by pressing the
Trip Reset
button on the module followed by
the
Alarm Reset
button. The NGC-
40
-HTC
3
might also be in alarm. Clear the NGC-
40
-HTC
3
alarm by pressing the
Alarm Reset
button
on the module.
• The NGC-
40
-HTC
3
should have its output ON. This is indicated by the green LED (Output Relay). The SLIM Output Relay LED should
also be ON. If the NGC-
40
-HTC
3
output is OFF then rotate TS
1
until the output turns ON.
SLIM Reset Button