Nickel-plated copper bus wires
Self-regulating conductive core
Polymer-coated aluminum wrap
Tinned-copper braid
Modified polyolefin inner jacket
HWAT
Modified polyolefin
outer jacket
Nickel-plated copper bus wires
Self-regulating conductive core
Polymer-coated aluminum wrap
Tinned-copper braid
Modified polyolefin inner jacket
HWAT
Modified polyolefin
outer jacket
Black washer
Do not cut
metal braid or
inner jacket.
6 1/2 in
24 in.
(60 cm)
• Unscrew cable gland (Item L).
• Discard white washer and use black washer
(Item M) instead.
• Slide nut, washer and grommet over the cable as
shown.
• Bevel on the washer should face into the nut.
• Lightly score completely around
and then down outer jacket.
• Bend heating cable to break jacket
at score then peel off outer jacket.
Power Connection Installation
• Carefully slide screwdriver
underneath the braid and poke
tip of screwdriver up through
2-3 bundles of the braid wire.
• Straighten out braid wire
• Repeat until entire length of braid is unraveled.
• Slowly pull
back on
screwdriver to
unravel
braid.
1
2
3
4
5
6
7
8
9
0
2 | nVent.com
1
2
3
4
