Do not cut
bus wires.
1/2 in
6 in
Do not cut
bus wires.
1/4 in
• Using wire cutters, cut
away aluminum wrap.
• Straighten the braid and
twist braid into a pigtail.
• Do not shorten the braid.
• Notch core at the end
• Twist back and peel bus wires
from core
• Score between
bus wires at base
jacket
• Bend core to break
free at base jacket
• Peel core and any
remaining material
from bus wires
• At the end of each heating cable, lightly score completely
around and down inner jacket
• Bend heating cable to break jacket at score, then peel off
inner jacket
• Slide heat-shrinkable tubes (Item E) over the
bus wires.
• Starting from the center of the tube, move the
heat source continuously from side to side.
• Slide heat-shrinkable tube (Item J)
over the stripped portion of the cable,
until tube butts up against the outer
jacket.
• To prevent the shrink tube
from moving, slightly spread
the bus wires to hold tube in
place while shrinking.
CAUTION: Health
Hazard. Consult
material safety data
sheet RAY3122.
1
2
3
4
5
6
7
8
9
0
IMPORTANT: If using a
torch, be careful not to
overheat, char or
damage the tube.
nVent.com | 3
5
6
7
9
10
8
