End Seal Installation for HWAT Heating Cables
1"
• Score down and around outer jacket 1 inch from the end.
• Remove the outer jacket.
• Do not cut or damage inner jacket.
• Using wire cutters, cut away aluminum wrap close to
braid and outer jacket.
• Remove exposed braid.
• Push end seal completely onto heating cable.
• Wipe off excess gel that may ooze out after you insert the
heating cable.
Note: The end seal can be installed only once; it cannot be
removed from the heating cable.
1
2
3
4
5
6
0
North America
Tel +
1
.
800
.
545
.
6258
Fax +
1
.
800
.
527
.
5703
thermal.info@nvent.com
Europe, Middle East, Africa
Tel +
32
.
16
.
213
.
511
Fax +
32
.
16
.
213
.
604
thermal.info@nvent.com
Asia Pacific
Tel +
86
.
21
.
2412
.
1688
Fax +
86
.
21
.
5426
.
2917
cn.thermal.info@nvent.com
Latin America
Tel +1.713.868.4800
Fax +
1
.
713
.
868
.
2333
thermal.info@nvent.com
©
2019
nVent. All nVent marks and logos are owned or licensed by nVent Services GmbH or its affiliates. All other trademarks are the property of their respective owners. nVent reserves the right to change
specifications without notice.
Raychem-IM-H
59091
-HWTP-EN-
1901
1
2
3
4
nVent.com
