CPCI Serial System 3+1 U
Installation
24579-415
www.schroff.biz
12
R1.0, July 20, 2011
3.2 Rack-Mounting
This subrack system can be installed in 19“ equipment racks. The rack must be
accessible from the front and rear for equipment installation.
Mounting Instructions:
•
Ensure that the rack is constructed to support the weight and dimensions of
the system.
•
Install any stabilizers that came with your equipment rack before mounting
or servicing the system in the rack.
Load the rack from the bottom to the top, with the heaviest system at the bottom,
avoid uneven mechanical loading of the rack.
3.3 Initial Operation
•
Ensure that the system has not been damaged during transport, storage or
assembly.
•
Check the Protective Earth (PE) resistance, should be < 0,1 Ohm.
•
Switch on the system and check the supply voltage directly on the
backplane connectors before the board assembly.
Note:
The ATX power supply requires a minimum load!
•
Plug-in the boards
•
Cover all open Slots with filler panels.
Mounting Kit
A rack mounting kit comes with the system.
Warning!
This equipment is intended to be accessed, to be installed and maintained by
qualified and trained service personnel only.
This equipment is designed in accordance with protection class 1!
It must therefore be operated only with protective GND/earth connection!
