20
2.
3.
Proper Condition
Improper Condition
It is advised to place the PSU on a flat, stable surface.
While you secure the PSU in place, use
two thumbs to insert the retainer's two snaps into the designated holes located near the AC
inlet. Make sure that the retainer's plastic loop is facing upwards, as demonstrated in the
below table.
Correct Insertion
Incorrect Insertion
Push the retainer until the shoulders' pins (in blue circles below) are open and aligned with
the PSU front panel, as shown in the following table:
For demonstration purposes, the images in this document show C2P (Connector-to-
Power) airflow PSUs with red latches, yet the instructions apply to P2C (Power-to-
Connector) PSUs with blue latches as well.
