31
Wizard Session Display (Example)
Comments
You have entered the following information:
Hostname: <switch name>
Use DHCP on mgmt0 interface: yes
Enable IPv6: yes
Enable IPv6 autoconfig (SLAAC) on mgmt0
interface: yes
Enable DHCPv6 on mgmt0 interface: yes
Admin password (Enter to leave unchanged):
(CHANGED)
HA Chassis IP address: 10.6.166.200
HA Chassis Management IP netmask: 255.255.255.0
HA Chassis IPv6 address:
fdfd:fdfd:7:145::1000:4814
HA Chassis Management IPv6 masklen: 33
To change an answer, enter the step number to
return to.
Otherwise hit <enter> to save changes and exit.
Choice: <Enter>
Configuration changes saved.
To return to the wizard from the CLI, enter the
“configuration jump-start” command
from configuration mode. Launching CLI...
<switch name> [standalone: master] >
The wizard displays a summary of your choices and
then asks you to confirm the choices or to re-edit
them.
Either press <Enter> to save changes and exit, or
enter the configuration step number that you wish
to return to.
To run the command “configuration jump-start”
you must be in Config mode.
Static IP Configuration
Wizard Session Display (Example)
Do you want to use the wizard for initial configuration? y
Step 1: Hostname? [switch-112126]
Step 2: Use DHCP on mgmt0 interface? [yes] n
Step 3: Use zeroconf on mgmt0 interface? [no]
Step 4: Primary IP address? 192.168.10.4
Mask length may not be zero if address is not zero (interface mgmt0)
Step 5: Netmask? [0.0.0.0] 255.255.255.0
Step 6: Default gateway? 192.168.10.1
Step 7: Primary DNS server?
Step 8: Domain name?
Step 9: Enable IPv6? [yes] yes
Step 10: Enable IPv6 autoconfig (SLAAC) on mgmt0 interface? [no] no
Step 11: Update time? [yyyy/mm/dd hh:mm:ss]
Step 12: Enable password hardening? [yes] yes
Step 13: Admin password (Enter to leave unchanged)?
You have entered the following information:
Hostname: switch-112126
Use DHCP on mgmt0 interface: no
Use zeroconf on mgmt0 interface: no
Primary IP address: 192.168.10.4
Netmask: 255.255.255.0
Default gateway: 192.168.10.1
Primary DNS server:
Domain name:
Enable IPv6: yes
Enable IPv6 autoconfig (SLAAC) on mgmt0 interface: no
Update time: yyyy/mm/dd hh:mm:ss
Enable password hardening: yes
Admin password (Enter to leave unchanged): (unchanged)
To change an answer, enter the step number to return to.
Otherwise hit <enter> to save changes and exit.
Choice:
Configuration changes saved.
To return to the wizard from the CLI, enter the “configuration jump-start” command from configure
mode. Launching CLI...
<hostname>[standalone: master] >