Nvis 5586A
Nvis Technologies Pvt. Ltd.
169
Serial Communication between two Nvis 5586A Trainers
For serial communication between the two trainers connect the male to male RS232 cable
provided with Nvis 5586A trainers. And follow the procedure given below
1.
On Nvis 5586A, execute from F000:F003 using G command as follows:
2.
Press Enter key and the following will come on the display:
For serial communication one trainer transmits data and other receives the data:
Procedure for transmitter trainer:
1.
For transmit data press F7 on trainer keyboard to come in the OUT mode.
2.
1st location indicates the starting address (F000:0400) and the 2nd location indicates the
end address (0400) of the memory area to be transmitted on to the Serial Port. Change
this to 0000:0400 to 04FF as follows:
Then press enter to transmit data
Procedure for receiver trainer:
1.
On Nvis 5586A, execute from F000:F003 using G command as follows:
2.
Press Enter key and the following will come on the display:
Change the location from F000:0400 to 0000:0400. This is the 1st RAM location data
will be received from the transmitter trainer and this address will keep on incrementing
on receipt of each Data Byte.
3.
Press enter button on trainer button & then press the enter button on transmitter trainer
Note:
Please short the jumper JP4 of both trainer on pin 1 & 2 for clock settings.
Summary of Contents for 5586A
Page 2: ...Nvis 5586A Nvis Technologies Pvt Ltd 2...
Page 23: ...Nvis 5586A Nvis Technologies Pvt Ltd 23 Memory Read Timing in Maximum Mode...
Page 30: ...Nvis 5586A Nvis Technologies Pvt Ltd 30...
Page 48: ...Nvis 5586A Nvis Technologies Pvt Ltd 48 Diagram of module RESET power Instruction Set Note...
