© by N&W GLOBAL VENDING S.p.A.
32
03-2012 3775 00
commuNicatioN
protocol
DDcmp
ENHaNcED
with the following configurable parameters:
-
Pass code
: it's a four digits numeric code (from 0 to
65535) that should be identical to the number on the
transfer terminal to allow identification.
Default settings: 0000
-
Security code
: it's a four digits numeric code (from 0 to
65535) used for mutual recognition between a machine
and an EVA DTS terminal.
Default settings: 0000
-
End of transmission
: if enabled, it is capable of rec-
ognising the end of transmission signal which is sent
with the last packet and of interrupting the data trans-
mission.
DEx
/
ucs
for this protocol there are no configurable parameters:
Data
traNsmissioN
This function allows you to select which communica-
tion interface to use for data transmission. The available
interfaces are:
-“Serial RS232” and “IrDA kit”: for the communication with
serial or infrared data acquisition devices.
-“ALWAYS EVA DTS” for communications with data acquisi-
tion and transmission devices (telemetry).
typE
This function allows you to select the mode to manage
the speed of communication through the data acquisition
devices:
-“ENHANCED”: communication speed is automatically
adjusted to the highest speed the slower machine can
support.
-“FIXED”, the communication speed is fixed to the speed
set with the Baudrate function
bauDratE
(
traNsmissioN
spEED
)
This allows you to choose the communication speed of
transmissions (only if “EVA DTS type” is set with “fixed”).
Default setting: 2400bps.
coNNEctioN
By activating this function, the machine waits for the con-
nection with a data acquisition device EVA DTS.
E
NabE
rEfill
Only for data with transmission data system.
The function allows the user to enable, by the end of the
starting cycle of the machine, a prompt for "refill code".
"Refill code" is a 4 digits code (1234 default) used to reset
running out products products alarms managing counters,
sent through data transmission system.
D
ElEtiNg
stats
The statistics can be reset, for the relative counters, in
a global mode (all types of data) or in a selective mode,
for:
-selections
-discounts/overprices
-faults
-coin box data
By pressing the confirmation key
�
the flashing confirma
-
tion request “Confirm?” is displayed.
By pressing the confirmation key
�
the message “Execution”
is displayed for a few seconds and the statistics are reset.
D
isplay
of
rElativE
statistics
By pressing the confirmation key
�
the stored data is
displayed in sequence:
1 - single selection counter;
2 - bands counter;
3 - faults counter;
4 - coin box data.
D
ElEtE
rElativE
stats
The statistics can be reset, for the relative counters, in
a global mode (all types of data) or in a selective mode,
for:
-selections
-faults
-coin box data
By pressing the confirmation key
�
the flashing confirma
-
tion request “Confirm?” is displayed.
By pressing the confirmation key
�
the message “Execution”
is displayed for a few seconds and the statistics are reset.
Summary of Contents for Festival
