Laser Site Calculator LSC60
Laser Site Calculator LSC60
33
EN
LSC60
4. Basics
Power On And Off
Long press
to power on the instrument and activate the laser. The
display is on and shows the battery symbol until the next button is
pressed.
Long press to power off the instrument.
The instrument will be switched off automatically after three minutes
of inactivity.
Reference Setup
See Figure (C)
Press
to switch reference point
between the top, the bottom,
tripod thread, and end-piece of
the instrument. There is a beep
warning tone when reference
point is changed.
The default reference setting is from the bottom of the instrument.
The reference point will be set to default every time when it’s powered
off, i.e. the measuring reference point is from the bottom of the
instrument every time when it’s powered on.
Figure (C)
Display Backlight
Press
to switch on or off the display backlight. User can trigger the
function when he/she is in dark situation. The value is clearly visible on
the display.
Distance Unit Setup
Long press
to change the distance unit between m, ft, in, ft+/in.
Long press again to continuously change the next unit.
Clear/Cancel
When measuring or calculating, user can press to cancel the last
action, until all data on display are cleared and go back to single
distance measurement interface.
Historical Data
View
Press
to view historical data, including 50 measured results, shown
in reversed order. Continuously press
to view the next record.
