34
5.2 0set
Function: set the horizontal angle as 0 °00′00″.
●
Press [F2](0set);
●
Asking ―Set 0?‖, press [ENT] to set 0 or [ESC] to exit this
operation. In order to make sure the accuracy, you may press
[ENT] lightly.
5.3 Hset
Function: Set the horizontal angle as wanted angle.
●
Press [F3] to enter the interface of ―Set HA‖ to set
horizontal angle ;
●
In the ―DMS‖ of angle unit mode, if you want to input
―123°45′56″‖
，
just input ―123.4556‖ in the input box. In the
other angle unit mode , input normally, as shown in picture
below:
Set HA
Exit
Clear
B.S
Enter
HR:
123.4556
●
Press [ENT] to confirm the input, or [ESC] TO to cancel.
When over 360°, it will tip ―Overtop!‖
5.4 Hold
Function:
Another method to set horizontal angle.
●
Turn around the alidade to the wanted horizontal angle and
press soft key [Hold], the turn around the alidade a and the
readout of horizontal angle is ‗hold‘ and not changing with
turning the alidade again, the horizontal angle remain the
same.
●
After turning the alidade to aim at the target, press the key
[F1] to set horizontal angle at a new position.
Hold
No
Yes
HR：
156°38′54″
> Set?
