81
Coord. Z
Setup STA
Coord.
List
Input
Enter
Pt.n：
1
Here, you can press [Coord.] to input station point, or press
[List] to retrieve coordinate from known files.
2)
Setup datum mark. You can press [2] (Datum mark) to enter
the interface of ―Coord.Z-No.1‖;
Coord.Z-No.1
>Pt.n：
Info.
List
Input
Searh
Code：
T.H：
1.700
m
[☆]Select file
Press [Input] to input the name, coordinates and target height of
the first point, whose input method is same as the it of backsight
point. Press [ENT] to end inputting and enter the measurement
interface of ―Coord.Z-No.1‖;
Coord.Z-No.1
HR:
170°12′23″
Meas
Enter
HD:
VD:
m
SD:
m
m
Mode
3)
Press [Meas] to start measuring. After measuring, the
measured value will be displayed, and you can press [Enter]
to
confirm
this
measurement,
then
the
keys
[Next] ,[Mode]and [Calc] appears. You can press [Next] to
continue the measurement , or [Calc] to enter the interface
of ―Coord.Z-Result‖;
Coord.Z-Result
BSA:
170°12′23″
SetZ
Z:
dZ:
m
m
1.234
0.001
Then you can press [SetZ] to set the Z coordinate of station, or
