Figure 21. i.MX mini SAS cable with LVDS-to-HDMI adapter
Figure 22. i.MX MIPI camera
NOTE
• To test the MIPI-DSI to HDMI display, use the i.MX mini SAS cable to connect
the DSI to HDMI adapter to the "MIPI DSI" port.
• To test the LVDS-to-HDMI display, use the i.MX mini SAS cable to connect the
LVDS-to-HDMI adapter to the "LVDS0/LVDS1" port.
• To test a single camera, connect the i.MX MIPI Camera to the "MIPI Camera" port
or connect OV5640 Camera to the "CSI Camera" port.
• To test dual cameras, connect both.
6.2 Board images
The table below describes the location in the board partitions of the software images in android_p9.0.0_2.0.0-
ga_image_8qmek.tar.gz.
Table 7. Board images
Image name
Download target
/u-boot-imx8qxp.imx
32 KB offset of MMC.
/u-boot-imx8qxp-mek-uuu.imx
Bootloader used by UUU for the i.MX 8QuadMax MEK
board. It is not flashed to MMC.
/partition-table.img
Program to the first 17 KB, and then back up to the last 17
KB of the boot storage. GPT table image for 16 GB boot
storage.
/partition-table-7GB.img
Program to the first 17 KB, and then back up to last 17 KB
of the boot storage. GPT table image for 8 GB boot storage.
/partition-table-28GB.img
Program to first 17 KB, and then back up to last 17 KB of
the boot storage. GPT table image for 32 GB boot storage.
/boot.img
boot_a and boot_b paritions
/vbmeta-imx8qxp.img
vbmeta_a and vbmeta_b partitions to support single LVDS-
to-HDMI/MIPI-to-HDMI or dual LVDS-to-HDMI display with
dual-camera support.
/system.img
system_a and system_b partitions
/vendor.img
vendor_a and vendor_b partitions
Table continues on the next page...
Working with the i.MX 8QuadXPlus MEK Board
Android™ Quick Start Guide, Rev. P9.0.0_2.0.0-ga, 04/2019
26
NXP Semiconductors
