NXP Semiconductors
KTFRDMHB2001FEVMUG
FRDM-HB2001FEVM evaluation board
KTFRDMHB2001FEVMUG
All information provided in this document is subject to legal disclaimers.
© NXP B.V. 2016. All rights reserved
User guide
Rev. 1.0 — 25 May 2016
16 / 35
5.1 Connecting the FRDM-KL25Z to the board
The FRDM-KL25Z evaluation board was chosen specifically to work with the FRDM-
HB2001FEVM kit because of its low cost and features. The FRDM-KL25Z board makes
use of the USB, built in LEDs and I/O ports available with NXP’s Kinetis KL2x family of
microcontrollers.
The FRDM-KL25Z connects to a PC through a USB port, which permits the user
to control a DC brushed motor and to drive the evaluation board inputs in order to
operate the motor via the GPIOs and SPI pins. The FRDM-KL25Z also monitors the SPI
registers, thereby facilitating the use of safety and advanced diagnostic functions.
The FRDM-HB2001FEVM connects to the FRDM-KL25Z using the four dual row
Arduino
™
R3 connectors on the bottom of the board (see
Table 9
,
Figure 11
and
Figure
12
).
Figure 11. Connecting the FRDM-HB2001FEVM to the FRDM-KL25Z
