TIXU_MX6Y
Rev. A1_02
15
4.9.3
JTAG Connector
User can use header H5 for the JTAG communication. Segger J-link Base is compatible with this 2.54mm 20 pin
header.Please connect the J-link Base as shown below.
4.9.4
GPIO Header
User can access 10 gpios from the header H4. This is for user defined purpose.
4.10
Powering the board
User can use a 5V, 5A adapter to meet the power requirement of the EVAL board. There is a DC power
jack J1 for the power input. After inserting the DC plug of the adapter to the jack please use switch SW1 to turn on
the power.
Figure 16: Connecting adapter.
4.11
On-board LED Information
Below is the information about all LED used in the board. The marking no used in figure 1 are referenced
here to show the position of each LED.
Marking Number
Function
1
This Dual colour LED will show the status of J6 USB connector
2
This Dual colour LED will show the status of J5B USB connector
3
This Dual colour LED will show the status of J5A USB connector
4
This Dual colour LED will show the status of J4B USB connector
5
This Dual colour LED will show the status of J4A USB connector
6
This will show the status of 5V from the adapter
