Replace
sdX
with your own SD card 'node name' detected by the system.
NOTE
Deploying kernel and device tree image
Kernel and device tree image are stored in the first partition (vfat) of SD card.
$ cp -avf imx6q-sabresd.dtb /mnt
$ cp -avf zImage /mnt
$ umount /mnt
/mnt
is the mount point of the vfat partition.
NOTE
3.8 LS1028ARDB and LS1028ATSN
The QorIQ
®
LS1028A reference design board (LS1028ARDB) is a computing, evaluation, development, and test platform
supporting the QorIQ LS1028A processor, which is a dual-core Arm
®
Cortex
®
-v8 A72 processor with frequency up to 1.3 GHz.
The LS1028ARDB is optimized to support SGMII (1 Gbit/s), QSGMII (5 Gbit/s), PCIe x1 (8 Gbit/s), and SATA (6 Gbit/s) over
high-speed SerDes ports, USB 3.0, DisplayPort, and also a high-bandwidth DDR4 memory. The LS1028ARDB can be used to
develop and demonstrate human machine interface systems, industrial control systems such as robotics controllers and motion
controllers, and PLCs. The reference design also provides the functionality needed for Industrial IoT gateways, edge computing,
industrial PCs, and wireless or wired networking gateways.
LS1028ATSN board integrates three SJA1105 TSN switches, which will extend the TSN switch to 12 ports.
3.8.1 Switch settings
The following table lists and describes the switch configuration for LS1028ARDB board.
Platform
Boot source
SW setting
LS1028ARDB
SD
sw2: 0b’10001000
3.8.2 Interface naming
The following section ddescribes the association between physical interfaces and networking interfaces as presented by the
software.
3.8.2.1 Interface naming in U-Boot
The following figure shows the Ethernet ports as presented in U-Boot:
Note: In U-Boot running on RDB, only
enetc#0
is functional.
NXP Semiconductors
NXP OpenIL platforms
Open Industrial User Guide, Rev. 1.8, 05/2020
User's Guide
32 / 199
