NXP Semiconductors
UM11587
KITVR5510xA0EVM Evaluation Kit User Guideline
7 Installing and Configuring Software and Tools
Unzip the NXP_GUI_PR_4.1.0 into any desired location. Find the NXP_GUI-4.1.0-
Setup from the GUI folder inside the package and run it to install the GUI in any desired
location.
7.1 Freedom board BOOTLOADER refresh in a Windows 7 system
Note: This procedure does not apply if the board is already programmed.
1. Ensure that the boot loader in the GUI package is the latest specified in the link below.
If not, download the latest boot loader for the specific MCU(K82F) from the location
below:
https://os.mbed.com/blog/entry/DAPLink-bootloader-update/
2. Press the RST push button on the Freedom board and connect the USB cable to the
SDA port (J5) on the Freedom board. A new “BOOTLOADER” device appears on the
left pane of the File Explorer.
Figure 13. Freedom board
3. Drag and drop the downloaded file “0244_k20dx_bootloader_update_0x8000.bin” into
the BOOTLOADER drive.
Note:
Ensure that enough time is allowed for the firmware to be saved in the boot
loader.
4. Disconnect and reconnect the USB cable into the SDA port (this time without pressing
the RST push button).
5. Drag and drop the file “k20dx_frdmk82f_if_crc_legacy_0x8000.bin” from the package
(MCU/K82F_FW folder) into the BOOTLOADER drive.
Note:
Make sure to allow enough time for the firmware to be saved in the Bootloader.
The device should change to FRDM_K82FD.
6. Locate the file “nxp-gui-fw-frdmk82f-usb_hid-vr5510_b0_v0.7.3.bin” from the package
(MCU/K82F_FW folder) and drag and drop the file into the FRDM_K82FD device.
7. The Freedom board firmware is successfully loaded. Disconnect and reconnect the
USB cable to the USB port. Open the previously installed NXPGUI. The “Start” button
on the top left corner must be activated.
UM11587
All information provided in this document is subject to legal disclaimers.
© NXP B.V. 2021. All rights reserved.
User manual
Rev. 1 — 3 May 2021
19 / 32
