NXP Semiconductors
KTFRDM34933EVBUG
FRDM-34933EVB evaluation board
KTFRDM34933EVBUG
All information provided in this document is subject to legal disclaimers.
© NXP B.V. 2017. All rights reserved.
User guide
Rev. 1.0 — 15 March 2017
9 / 39
FRDM LV stepper motor
FRDM-KL25Z
Header
Pin
Name
Header
Pin
Name
JA4
5
J4
10
PTC2
JA4
4
AUX_IO5
J4
8
PTB3
JA4
3
J4
6
PTB2
JA4
2
AUX_AN2
J4
4
PTB1
JA4
1
AUX_AN1
J4
2
PTB0
6 Installing the software and setting up the hardware
The latest version of the Motor Control GUI is designed to run on any Windows 10,
Windows 8, Windows 7, Vista, or XP-based operating system. To install the software,
go to
www.nxp.com/analogtools
and select your kit. Click on that link to open the
corresponding tool summary page. Look for “Jump Start Your Design”. Download
the Motor Control GUI software to your computer desktop (
LVMC-Steppermotor-
setup.exe
).
Run the installed program from the desktop. The Installation Wizard guides you through
the rest of the process.
To use the Motor Control GUI, go to the Windows Start menu, then Programs, then Motor
Control GUI, and then click the NXP icon. The Motor Control Graphic User Interface
(GUI) appears. The GUI is shown in
Figure 3
. The hex address numbers at the top are
loaded with the vendor ID for NXP (0x15A2), and the part ID (0x138). The panel on the
left side displays these numbers only if the PC is communicating with the FRDM-KL25Z
via the USB interface.
Figure 3. Motor Control GUI
6.1 Configuring the hardware
Figure 4
and
Figure 5
show the configuration diagrams for single stepper motor and DC
motors.
