Quick Installation Guide
2-12
M68VZ328ADS USER’S MANUAL
MOTOROLA
2.3.2 Connecting M68VZ328ADS to PC
Figure 2-6 shows connections among the PC, the external power supply and the
M68VZ328ADS board. Use the following steps to complete cable connections:
For most evaluation platforms, serial communication is the primary channel to link up PC
with the target board. Both Microtek (SLD) and Software Development System (SDS) debug
monitor support serial communication through UART port. The procedure are as follows.
1. Connect a RS232 cable from COM port (COM1 or COM2) to connector P2 of
M68VZ328ADS.
2. Connect the power 3V or power adaptor to the P1 of M68VZ328ADS
3. Turn on the power supply. The RED LED will flash and the GREEN LED will illuminate
when power is correctly applied.
2.3.3 Installing software debugger
The following software debugger supports M68VZ328ADS:
• Metrowerks Codewarrior
• Single Step Development System
• SLD
Metrowerks Codewarrior
A simple procedure for using Metrowerks Codewarrior Target Monitor:
1. Install the Metrowerks Codewarrior IDE
3.0-3.3V
Power Supply
UART1
UART2
Host Computer
COM1
/ COM2
RS232 Cable
M68VZ328ADS
Figure 2-6. Connecting PC to UART1 of M68VZ328ADS
Freescale Semiconductor, I
Freescale Semiconductor, Inc.
For More Information On This Product,
Go to: www.freescale.com
nc.
..
