Table 8. (continued)
CUR_DCB
D12/SPI_MISO
NC
D13/SPI_CLK
NC
GND
NC
AREF
NC
D14/I2C_SDA
NC
D15/I2C_SCL
J60 is defined as Motor control Interface. The pin definitions of Motor control Interface are shown in below table. All the connectors
support motor control.
Table 9.
J60
PWM_AT
VIN
PWM_AB
GND
PWM_BT
GND
PWM_BB
5V
PWM_CT
3V3
PWM_CB
RESET_b
ENC_A
IOREF
ENC_B
NC
2.10 ON/OFF Button
SW2 is the ON/OFF button for MIMXRT1010 EVK Board. A short pressing in OFF mode causes the internal power management
state machine to change state to ON. In ON mode, a short pressing generates an interrupt (intended to be a software-
controllable(power-down). An approximate 5 seconds or more pressing causes a forced OFF.
2.11 Reset Button
There are two Reset Button on the EVK Board. SW9 is the Power Reset Button. Pressing the SW9 in the Power On state will force
to reset the system power except SNVS domain. The Processor will be immediately turn off and reinitiate a boot cycle from the
Processor Power Off state. SW3 is POR Reset Button.
Specifications
MIMXRT1010 EVK Board Hardware User’s Guide, Rev. 0, 30/07/2019
12
NXP Semiconductors
