NXP Semiconductors
UM10935
PN7150 NFC Controller SBC Kit User Manual
UM10935
All information provided in this document is subject to legal disclaimers.
© NXP B.V. 2019. All rights reserved.
User manual
COMPANY PUBLIC
Rev. 1.5 — 10 July 2019
348015
21 of 25
6.2.2 Installation instructions
PN7150 NFC Controller board can be reused as a module for integration into end
devices following below instruction/restrictions:
•
The module is limited to OEM installation ONLY
•
The OEM/Integrators are responsible for ensuring that the end-user has no manual
instructions to remove or install module
•
The module is limited to installation in mobile or fixed applications, according to Part
2.1091(b)
•
Separate approval is required for all other operating configurations, including
portable configurations with respect to Part 2.1093 and different antenna
configurations
•
Authorized antennas per Part 15.204 (including ant. spec.)
•
Antenna installation requirements, where relevant
•
The finished product’s user manual must include following statements:
o
Part 15.19 Warning Statement:
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
o
Part 15.21 Warning Statement:
The user manual for an intentional or unintentional radiator shall caution the
user that changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
Note: The grantee is not responsible for any changes or modifications not
expressly approved by the third party responsible for compliance. Such
modifications could void the user’s authority to operate the equipment.
o
End-users must be provided with transmitter/antenna installation
requirements and operating conditions for satisfying RF exposure compliance:
A separate section should clearly state “FCC RF Exposure requirements”
Required operating conditions for end users
Antenna/or transmitter installation requirements, where relevant (for
example: The antenna used with this module must be installed to provide
a separation distance of at least 20 cm from all persons, and must not
transmit simultaneously with any other antenna or transmitter.)
o
« Contains Transmitter module FCC ID :OWROM5575-PN7150S » or
«Contains FCC ID : OWROM5578-PN7150S »
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
