P1010RDB-PB Quick Start Guide, Rev. 0
Freescale Semiconductor
3
Getting Started
u-boot-nand.bin
p1010.dtb
uImage.p1010
fsl-image-core-p1010rdb-20130615092723.rootfs.ext2.gz
•
On-board NOR Flash and SPI flash are both loaded a bootable image, too.
2.2
Default Booting Method and Switch Settings
The default booting method and switch settings are:
•
The default booting setting is NAND Flash.
•
The default settings result in the following frequency settings:
CPU = 1000 MHz, CCB = 400 MHz and DDR = 800MT/s data rate.
2.3
Booting the Board
Follow the given steps to boot a target board:
1. Set the switch settings for SW1, SW2, SW3, SW4 and SW5 as illustrated here. For more details
on decoding the switch settings, refer to the
P1010RDB-PB Hardware User Guide
.
Figure 2. Switch Settings
2. Ensure all of jumper settings are set as shown.
Figure 3. Jumper Settings
3. Plug one terminal of the DC power adapter into the receptacle on the back of the chassis, and plug
the other terminal AC cable into 100~240V AC power supply.
