BL ID
Hardware Manual
Project Name: Integration Manual Project ID: 62743
2. Customer Evaluation Board PNEV5180B: Description
1.
Operational desription
Customer Evaluation Board PNEV5180B is an example of implementation of ISO/IEC 14443A and ISO/IEC
14443B reader/writer, NFC reader/writer and Card Emulation Device on the same printed board. Middle size
antenna, implemented on the same pcb (reader and antenna can be broken into separate parts), permits
reading/writing on distance up to 50 mm (RFID card or other NFC device). The onboard USB connector permits
direct connection and communication with personal computer.
Power supply is via usb port or via external power supply (7.5 V / 500 mA).
On the Customer Evaluation Board PNEV5180B main parts are easily visible:
•
the pcb antenna (can be separated from matching part),
•
the antenna matching components (can be separated from reader and antenna part),
•
the reader part: PN5180 reader IC, LPC 1769 microcontroller IC, two crystall oscillators and decopling
capacitors, power supply ICs and EEPROM, USB serial communication port and JTAG port.
The Customer Evaluation Board PNEV5180B uses USB serial communiation port for communicating with
personal computer and transfer data. JTAG port is for development purposes (programming). Some test pins
are added on pcb.
The Customer Evaluation Board PNEV5180B has following features:
•
Supports ISO/IEC 14443A and ISO/IEC 14443B reader/writer up to 848 Kbps.
•
Supports MIFARE 1K/4K encryption in reader/writer mode.
•
Supports contactless RF communication according to the FeliCa protocol at 212 Kbps and 424 Kbps.
•
Supports all NFCIP-1 modes up to 424 Kbps. The PN512 handles the complete NFC framing and error
detection.
•
Supports the reading of NFC Forum Tag Types 1,2,3,4,5
•
P2P supported for types: A (106 kbit/s), F (212, 424 kbit/s)
•
ISO/IEC15693 reader (I-Code)
•
ISO/IEC 18000 EPC-HF reader (I-Code ILT)
•
EMVCo 2.4 L1 digital & analog Compliance
•
Card Emulation: ISO/IEC 14443A (up to 848 kbit/s)
•
Serial communication via USB port with Personal computer
•
Power supply via USB port or via external power adapter.
Disclaimer
:
This module is intended only for development and evaluation purposes, and cannot be used in a finished
product.
STS Template 1.0
public
© NXP B.V. 2015. All rights reserved
Doc ID: DOC-XXXXXX
Doc Rev 1.00 Preliminary — 2015.11.13
6 of 16
