NXP Semiconductors
S32K312EVB-Q172 HWUM
S32K312EVB-Q172 | S32K312EVBQ172ND - Hardware User Manual
S32K312EVB-Q172
S32K312EVBQ172ND
HWUM
All Information provided in this document is subject to legal disclaimers
© NXP B.V. 2020. All rights reserved
NXP Semiconductors
REV A1
– 01/2022
Page
21
of
25
Table 13. User Pushbuttons
Reference
Function
MCU
Port
Comments
SW5
USER_SW0
PTB26
Disabled
SW6
USER_SW1
PTB19
Enabled as DEFAULT
PTF31
Disabled
PTC18
Disabled
1.
There are zero-ohm resistors on the direct connections between each
USER_SWx
and the MCU pins. These can be removed
if required to isolate or change the User Switch from the default MCU pin.
11.3 ADC Rotary Potentiometers
The EVB incorporates a couple of ADC Rotary Potentiometer [which routes a voltage between 0v to VD_HV_A] directly connected to
ADC Precise Input Chanel of the S32K312 Microcontroller.
Table 14. ADC Potentiometers
Reference
Function
MCU Port
Comments
R393
ADC_POT0
PTA11
Enabled as DEFAULT
PTA9
Disabled
NOTE
1.
There are zero-ohm resistors on the direct connections between each USERSW and the MCU pins. These can be removed if
required to isolate or change the User Switch from the default MCU pin.
Figure 20. S32K312EVB-Q172
– ADC Rotary Potentiometers
