NXP Semiconductors
UM10276_1
TED-Kit 2 User Manual
All information provided in this document is subject to legal disclaimers.
© NXP B.V. 2010. All rights reserved.
User manual
Rev. 1.29 — 20 August 2010
11 of 79
a. collapsed
b. expanded
Fig 8. Hardware view
Note: TED-Kit 2 boxes can be plugged-in before or after starting the GUI. They are
automatically detected. The hardware can also be removed at any time while the
GUI is running.
Expanding the nodes will show the configuration of each TED-Kit 2 box according to the
XSlots and XBoards plugged in. For each XBoard found, the connected antenna(s) are
shown in the tree also (Fig 8b).
The TED-Kit 2 box currently connected has one XBoard: In slot #0, an ABIC1 which is
connected to LF antenna #0 (LF0). The slots #1, #2 and #3 are empty. The Hardware
View information is shown in Fig 9.
Fig 9. Hardware view details
To get an even more detailed look at each TED-Kit 2 box, double-click on the tree node
of the TED-Kit 2 of interest. A window showing all details available opens (refer to section
6.5 for details).
Double-clicking an ABIC1 node shown in the hardware view will open the ABIC1 XBoard
configuration window explained in section 6.6.1.
Double-clicking a LoPSTer node will open the LoPSTer XBoard configuration window
explained in section 6.6.2.
