35
Installation of the v-groove and height adjustor
•
Remove the front cover for the v-groove clamp (kept in place by magnets) and place the v-groove clamp block (v-groove
oriented towards the v-groove clamp cylinder) in position. Make sure the v-groove slide ramp is clean and free of debris.
•
Remove the rear cover by unscrewing the two hexagon screws holding it down with the supplied 2.5 mm Allen key.
•
Place the height adjustor as shown on the image below, make sure that the spring is located in the small hole at the back
of the fixed clamp block and that the pin from the miniature cylinder is fitted into the hole of the height adjuster.
•
Mount the front and rear cover back and tighten the two hexagon screws on the rear cover just until you feel a small
resistance. Do not over tighten!
