- 6 -
1. After connection, slide the power switch to the ON position to turn the
modulator ON.
2. By default, the modulator is set to CATV mode, if this is the proper TV
mode then you can choose a channel at this point.
3. You can select the channel by pressing the CH + and CH- buttons on
the front of the modulator, the current channel will be displayed on the
LED display.
4. If CATV is not the right mode, follow the “Changing Modes” directions
and then choose the channel using the same method in step 3.
5. Choose an unused channel for best operation and the least amount
of interference.
Channel
Display
Channel Up
and Down
Buttons
OPERATION