New York Standard Watch Company
.
www.newyorkstandardwatch.com
NYSW
Instruction Manual
-
Atomic (Radio Controlled) 3 Hands watch for USA and Europe.
IM code: M55A
INTRODUCTION
Congratulations on your recent purchase of the NYSW Radio Controlled Atomic Time Watch. Be sure to read the “Quick Set Up”
manual before using the watch for the
fi
rst time. The following instructions have more detailed information about our watches than
the “Quick Set Up Guide”. Please keep this manual in a safe place for future reference.
Your Atomic (Radio Controlled) Watch is a Multi-Band Radio Control Watch.
It incorporates a highly sensitive radio receiver that receives time signals from
USA, UK, Germany
or
Japan
automatically accord-
ing to your Time Zone setting on the Watch.
**
Your Radio Controlled Watch even changes automatically for Daylight Saving Time (when applicable).
Automatic Time Setting
Your Atomic Time (radio controlled) Watch recalls the available Atomic Clock signal automatically at 3:00AM every night accord-
ing to your Time Zone setting (go to Travel Around the World for details). After the signal from the tower is received it will show the
of
fi
cial local time on the watch. Everything is done automatically.
BEFORE USING THE ATOMIC WATCH
Check to determine if your watch is set on the OFF mode, which is the (Sleeping mode)…..If it is please do the following…
If your watch stops at 12 o’clock when you purchased it, this shows that your watch is in the OFF mode or Sleeping Mode for power
saving. To turn it ON, just push any button for 1 second and your watch will run fast to match the internal running time. Wait until the
watch has stop fast running and resume normal step-by-step running.
Please disregard this procedure if your watch is running normally at the point of purchase.
BUTTON FUNCTIONS
S1
(is
the
upper
button):
●
Press and holding S1 to manually search for the radio signal.
●
Press-release S1 once to show
the signal reception Succeed (OK at 12 O’clock) or Fail (NG at 6 O’clock)
S2
(is
the
middle
button):
●
Second-hand re-calibration
S3
(is
the
lower
button):
●
Press and release S3 to show USA time zone setting (indicate by Red/Green LEDs)
●
Press and holding S3 to show current Global Time Zone setting
Check USA Time Zone Setting
1. Press-release S3 once while the watch is running normally.
2. LED light indicates the USA Time Zone setting as below:
RED (Stable light) = Paci
fi
c (P)
Green (Stable light) = Mountain (M)
RED (Flashing light) = Central (C)
Green (Flashing light) = Eastern (E)
RED+GREEN
light
fl
ashing at the same time = not being set to a USA Time Zone
3. Press-release S3 to Exit
USA Time Zone Setting
There are 4 time zones across USA namely Paci
fi
c (P), Mountain (M), Central (C), Eastern (E). LED light indicates the USA Time
Zone setting. Follow the below procedures to set USA Time Zone:
1. Press-release S3 once while the watch is running normally
2. LED lights up underneath from the watch dial (watch face) to show the current USA Time Zone setting of the watch
3. Press-release S1 or S2 to set the watch to a new USA Time Zone according to the following table:
RED (Stable light) = Paci
fi
c (P)
Green (Stable light) = Mountain (M)
RED (Flashing light) = Central (C)
Green (Flashing light) = Eastern (E)
OK
NG
AM
PM
S1
S2
S3
